ERROR: UAD2CommDev: Failed to update access device loader !
MSG: UAD2CommDev: Couldn't execute required Loader Update over Ethernet !If you use an old access device with a new UDE version, there may be a loader update for the Access Device required. This update can't be applied over Ethernet, please follow the steps below, to update the loader...
To update a UAD2+, which is normally connected over Ethernet, you must
connect the UAD2+ using USB or FireWire and apply the update. - Unplug the power cable from UAD2+.
- Connect the UAD2+ to your PC using USB or FireWire.
- Target connection is not required, the update is also applied without.
-
Plug in the power cable.
-
You should see the Access Device in windows device manager now (Group: pls Debugging Devices).
-
Start UDE.
-
Open a Workspace (or generate a new one).
-
Select your UAD2+.
-
Try to connect to target.
-
The loader update will now be applied automatically (additional info here )
-
If the update was successful, you will see a message in command
view:
MSG: UAD2CommDev: Loader update succeeded, new version: Vx.xx.xx -
You can ignore the errors about not connected target.
-
Disconnect Power and USB/FireWire.
-
You can use the UAD2+ over Ethernet now.
If there are some problems, please contact
This e-mail address is being protected from spam bots, you need JavaScript enabled to view it
|
