An update of the IO Pod configuration is needed, if you see this message...

This error message was caused by UDEs symbol engine database.

For diagnostic of the problem run the tool ..

If you use an old access device with a new UDE version, there may be a loader update for the Access Device required. This update can’t be applied over Ethernet, please follow the steps below, to update the loader...

You may get this message, if you update the UDE version and there is a new version of firmware/loader for the Access Device included. This update is normally applied automatically...

This means that the communication with the monitor on target is not ok.

If you get this error message while connecting per ASC Bootstrap Loader (BSL), you may check the following points:

What is it?

What are reasons of this error message and how can I solve it?

SimIO or Simulated I/O is one of the UDE features ...

You can configure advanced break conditions (In addition to breakpoints) ...

Usually the program code should handle the TriCore exceptions/traps by correct initialisation of the BTV (Trap Vector Table Pointer) register and providing a trap vector table ...

While downloading of a program code the target pattern are checked via a CRC checksum algorithm ...

While ROM stepping the trap handling by the debugger is not possible, because the traps cannot be caught by UDE ...